CCENT (ICND1 100-101) IP Services Challenge

CCENT ACLs

CCENT Fun!

I have some new software that I will be using to create all types of new challenges for you here at AJSNetworking.com in the area of CCENT and other topics. Until then, let’s try a little Access Control List scenario the old fashioned way! Submit your configuration in the comments below and I will provide your score. Good luck!

CCENT ACL Scenario 1:

R1-Gi0/0———-Gi0/0-R2

Configure a named standard access list on R1 with the following parameters:

  • Use an ACL name of MYCCENTACL
  • Block all traffic from 10.10.10.100, and ensure other systems are not blocked; use the HOST keyword
  • Assign this ACL inbound on the Gi0/0 interface of R1

Remember, post the R1 configuration in the comments below for grading. Good luck and do not rush your answer!
Cisco Learning Network Store Promotions Page

8 thoughts on “CCENT (ICND1 100-101) IP Services Challenge

  1. Router(config)#ip access-list standard MYCCENTACL
    Router(config-std-nacl)# deny host 10.10.10.100
    Router(config-std-nacl)# permit any
    Router(config-std-nacl)#int gig0/0
    Router(config-if)#ip access-group MYCCENTACL in

  2. !Config access list
    ip access-list standard MYCCENTACL

    !Add ACE’s
    deny host 10.10.10.100
    permit any

    !Apply to interface
    interface Gi0/0
    ip access-group MYCCENTACL in

  3. Config terminal
    !
    Ip access-list standard MYCCENTACL
    deny 10.10.10.100
    permit any
    !
    Interface gigabit 0/0
    ip access-group MYCCENTACL in
    !
    exit

  4. Router(config)#ip access-list standard MYCCENTACL
    Router(config-std-nacl)# deny host 10.10.10.100 log
    Router(config-std-nacl)# permit any
    Router(config-std-nacl)#int gig0/0
    Router(config-if)#ip access-group MYCCENTACL in

Leave a Reply

Your email address will not be published. Required fields are marked *